| Electric Scooter Motor |
|---|
Specification:
Wheel (Inches): Diameter 12x2
Brake: Foot (Hand) Brake, Rear Wheel By Circuit Reaker
Battery Capacity: 12AH, 3x12V
Motor Power (W): 750
Recharge Times :Over 300 Times
Charging Period: 7-8hours
Speed (Mph): 12
Range (Mph): 19
Input Voltage Of Battery: 110v
Material Of Wheel: Rubber Charging Wheel
Material Of Scooter: Steel, Lacquer
Net Weight (Lbs):70
Gross Weight (Lbs):55
Maximum Load (Lbs):200
User Manual:
Quality Control:Our products are superior quality and all materials and components are inspected under strict quality control before packaging. The products are double boxed and well cushioned to ensure that they are intact during shipment.
Warning!
You should always ride your performance machine with the proper safety gear! Do not attempt any of the dangerous maneuvers. We assume no responsibility for any property damage or to any person sustaining any injury or death as a result of purchasing or viewing any of the content within this web site!
ELECTRIC SCOOTER MAINTENANCE:
Before operating your electric scooter:
• Make sure the tires are inflated properly. Small tires loose air pressure quickly and must be aired frequently. Most small tires can accept air pressure to 85 psi. This allows the tire to properly contact the surface and keeps the tube from rotating inside the tire during braking and acceleration. If the tube rotates, the valve stem will possibly be cut or torn from the inner tube. This will require replacement of the inner tube.
• Charge the battery. Batteries should be charged frequently, especially after prolonged usage that runs the battery down. Allow the batteries to cool for an hour or more before charging. Heat will damage batteries and it is helpful to keep batteries as cool as possible during use or charging.
• Keep the right tension on your drive belt (or chain) during use. A loose drive belt will allow the teeth to slip and wear at an excessive rate. Failure of the belt will occur due to slippage or the heat generated due to improper tension. The belt can be adjusted by moving the rear tire forward or aft. Check your specification, but look for approximately one-half to one-quarter inch gap when pressing against the middle of the span. It is important to prevent slippage.
• Do not ride electric scooters through water or mud, or even on wet grass since water can cause failure of the electrical components! Electric scooters are meant to be ridden on dry hard surfaces.